([Click here to download a PDF of this document](https://www.slee.com/assets/CrystalEdge%20GenInfo%20-%20Polished%20Edge%20Work.pdf)) # CrystalEdge® Polished Edge Work --- Our standard trophy blanks are fabricated with a variety of high polished edges. The most common is a "flat edge" with an arris on each side (small chamfers). The following sectional drawings will provide you with an overview of our edge finishes along with optional edges which are available on certain blanks. ### Flat Edge with Arris Standard on all Squares, Rectangles and blanks with straight line edges. Available as a substitute for our standard full pencil edge on Circles and Ovals at no additional charge. ### Edge #3 A full high polished mitered edge. This edge is used for many of our 3/4" thick premium quality trophy blanks. It is also used for a range of 3/4" thick premium trophy bases. These bases provide enough width to be etched directly on the mitered surface which is approximately 15/16" wide. A #3 Edge is available on straight line edges for 3/16”, 1/4”, 3/8”, 1/2” and 3/4" thick glass. ### Edge #4 A high polished edge with a steep bevel. This edge is also used for a wide variety of our premium trophy blanks. It is also used for a complete range of 3/8", 1/2" and 3/4" thick premium trophy bases. A #4 Edge is available on all straight line edges. ### Pencil Edge A high polish Pencil Edge is standard on Circles, Ovals and 1/2" thick Flames. A full pencil edge is not available on straight line edges. ### Ogee Edge The high polish Ogee Edge is available on all Circles and Ovals from 3/8" to 3/4" thick glass.
© 2019 The Slee Corporation. All Rights Reserved.